DIFFERENTIAL CONTROLLER

The Differential Controller assures continuous steam circulation and precise temperature control by making the vacuum pump maintain a constant differential between steam supply an return main pressures

VACUUM PUMP

The Vacuum Pump promotes steam circulation, sustains system vacuum, minimizes warm-up periods, and lowers the operating temperature of system components by exhausting the air and other non condensable gases from the system

RADIATOR TRAP

The Radiator Trap efficiently drains water and vents air from radiators to prevent steam from entering return piping

HEAT BALANCER

The Heat Balancer measures the system rate of heat flow in order to balance the heat input with heat demand

DIGITAL CONTROL CENTER

The MEPCO DCC1000 Digital Control Center uses microprocessor technology to continuously monitor the system sensors and adjust the control valve to supply the required amount of steam.  Its two line 16 character display and keypad allow communication, setting activations, readings and adjustment from one location

REGULATING VALVE

The SWRF Regulating Valve allows for precise control over steam to radiation ratios

OUTDOOR SENSOR

The Outdoor Sensor measures exterior weather conditions to determine the demand for heat inside the building.

 RESISTANCE THERMOMETER

The Resistance Thermometer measures the room temperature to prevent under and overheating

CONTROL VALVE

The Control Valve regulates the amount of steam entering the system as dictated by the Digital Control Center.

cooler steam. less steam. continuous steam. all help reduce heating bills up to 40%

control all of the settings or take readings from one single control panel located either on site or at a remote location.

the vari-vac controls monitor and respond to outside temperature changes so efficiently that rooms rarely vary more than one degree.

continuous steam flow eliminates the bangs and clangs of system warm-ups. tenants may forget what an old pressure heating system sounds like.

less wear! replace fewer traps and valves.

give the entire building, from the top floor to the ground level, the same heat input at exactly the same time.